Rangemaster Professional+ 100 Dual Fuel Guide de l'utilisateur télécharger pdf (Page 27)

INSTALLATION

Check the appliance is electrically safe and gas sound when you have nished.

ArtNo.070-0014 - Stability bracket - Wall fitting

Cooker

Stability bracket

Floor

3 mm min

Typical oor mounting

Typical oor mounting

Cooker

Outer stability

bracket

Floor

Wall

3 mm min

Typical wall mounting

Stability chain

ArtNo.010-0004 Moving the cooker

Fig.7-5

Fig.7-6

Lowering the Two Rear Rollers

To adjust the height of the rear of the cooker, rst t a 13 mm

spanner or socket wrench onto the hexagonal adjusting

nut (Fig.7-5). Rotate the nut – clockwise to raise – counter-

clockwise to lower.

Make 10 complete (360°) turns clockwise.

Make sure you lower BOTH REAR ROLLERS.

Completing the Move

Unfold the rear edge of the pack base tray. Open the grill

door and right-hand oven door so that you can get a good

grip on the bottom of the fascia panel as you move the oven

(Fig.7-6).

Carefully push the cooker backwards o the cardboard base.

Remove the pack base tray.

Position the cooker close to its nal position, leaving just

enough space to get behind it.



Do not use the door handles or control knobs to

manoeuvre the cooker.

Fitting the Stability Bracket or Chain

Unless otherwise stated, a cooker using a exible gas

connector must be secured with a suitable stability device.

Suitable stability devices are shown in Fig.7-7, Fig.7-8 and

Fig.7-9.

If you are using a stability chain (Fig.7-7) then the chain

should be kept as short as is practicable and xed rmly to

the rear of the cooker.

If you are using a stability bracket (Fig.7-8) and (Fig.7-9),

then adjust the bracket to give the smallest practicable

clearance between the bracket and the engagement slot in

the rear of the cooker.

Fit the bracket so that it engages as far as possible over the

chassis of the cooker.

Repositioning the Cooker Following

Connection

If you need to move the cooker once it has been connected

then you need to unplug it and, having gripped under the

fascia panel and lifted the front of the cooker slightly

(Fig.7-6), you need to check behind the cooker to make sure

that the gas hose is not caught.

As you progress, make sure that both the electricity cable and

gas hose always have sucient slack to allow the cooker to

move.

With a stability chain tted, release it as you ease the cooker out.

Do not forget to ret it when you replace the cooker.

When you replace the cooker, again check behind to make

sure that the electricity cable and gas hose are not caught or

trapped.

Fig.7-7

Fig.7-8

Fig.7-9

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Rangemaster Professional+ 100 Dual Fuel Guide de l'utilisateur Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Rangemaster Professional+ 100 Dual Fuel