Rangemaster Elan 90 Induction Guide de l'utilisateur télécharger pdf (Page 30)

The oven light is not working

The bulb has probably blown. You can buy a

replacement bulb (which is not covered under the

guarantee) from most electrical stores. Ask for an Edison

screw tting 15 W 230 V lamp, FOR OVENS. It must be a

special bulb, heat resistant to 300 °C (Fig. 6.1).

Before removing the existing bulb, turn o the power

supply and make sure that the oven is cool. Open the

oven door and remove the oven shelves.

Locate the bulb cover and unscrew it by turning it

counter-clockwise (it may be very sti ) (Fig. 6.2).

Now unscrew the existing bulb counter-clockwise,

taking care to protect your ngers with a glove in case

the bulb should shatter.

Screw in the new bulb clockwise and then screw the

bulb cover back on. Turn on the electricity supply and

check that the bulb now lights.

The oven door is misaligned

The bottom hinge of either oven door can be adjusted

to alter the angle of the door (Fig. 6.3).

Loosen the bottom hinge xing screws and use the

notch and a at bladed screwdriver to move the

position of the hinge to set the hinge position (Fig. 6.4).

Retighten the hinge screws.

ArtNo.320-0006 Oven door hinge adjustment 1

Eect of hinge adjustment – exaggerated for clarity

ArtNo.320-0007 Oven door hinge adjustment 2

Centre line of hinge pin

Oven door omitted for clarity

ArtNo.324-0005 Oven light bulb

Fig. 6.1

Fig. 6.2

Fig. 6.3

Fig. 6.4

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Pas de commentaire

Rangemaster Elan 90 Induction Guide de l'utilisateur Page 30