Rangemaster Professional + FXP Guide de l'utilisateur télécharger pdf (Page 29)

INSTALLATION

Check the appliance is electrically safe and gas sound when you have nished.

ArtNo.010-0004 Moving the cooker

ArtNo.325-0002 - BI oven removing the door

ArtNo.062-0001 - 90 Prof+ FX - Removing the door

Removing the Oven Door

To remove the oven door, open the door fully. Swivel the

locking ‘U’ clips forward to the locking position (Fig. 7.4). Grip

the sides of the door, lift upwards and then slide the door

forwards (Fig. 7.5.

Lowering the Two Rear Rollers

To adjust the height of the rear of the cooker, rst t a

13 mm spanner or socket wrench onto the hexagonal

adjusting nut (Fig. 7.6). Rotate the nut – clockwise to raise –

counter-clockwise to lower.

Make 10 complete (360°) turns clockwise.

Make sure you lower BOTH REAR ROLLERS.

Completing the Move

Unfold the rear edge of the cardboard base tray. Grip the

fascia panel and lift the front of the cooker slightly (Fig. 7.7).

Carefully push the cooker backwards o the pack base.

Remove the pack base. Position the cooker close to its nal

position, leaving just enough space to get behind it.



DO NOT use the control knobs to manoeuvre the

cooker.

Levelling

You are recommended to use a spirit level on a shelf in one of

the ovens to check for level.

Place the cooker in its intended position, taking care not to

twist it within the gap between the kitchen units as damage

may occur to the cooker or the units.

The front feet and rear rollers can be adjusted to level the

cooker. To adjust the height of the rear of the cooker turn the

adjusting nuts at the front bottom corners of the cooker. To

set the front feet turn the bases to raise or lower.

Fig. 7.4

Fig. 7.5

Fig. 7.6

Fig. 7.7

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Pas de commentaire

Rangemaster Professional + FXP Guide de l'utilisateur Page 29