Rangemaster RGG60 Guide de l'utilisateur télécharger pdf (Page 10)

INSTALLATION

Check the appliance is electrically safe and gas sound when you have nished.

• Gas Pressure tester

• Flexible gas hose

• Multimeter

You will also need the following tools:

Elec

tric drill

Jigsa

teel tape measure

ross head screwdriver

encil

djustable spanner

Shar

p knife

Checking the Parts

Check that the appliance is in a good condition after having

removed the packaging. In case of doubt, do not use the

appliance and contact the retailer.

The hob also has:

Stainless steel hob:

2 pan suppor

ts,

Glass hob: 4 individual pan supports.

Never leave the packaging materials (cardboard,

plastic bags, polystyrene foam, etc.) within children’s

reach since they could become potential sources of

danger.

Positioning the Hob

The hob should be fitted into a work surface, which is

at least 600mm deep. In position, it has a maximum

thickness of 50mm from the top of the work surface.

The cut-out dimensions are shown in (Fig.5-1) and

the minimum clearances in (Fig.5-2). The minimum

recommended distances from the hob to nearby surfaces

are shown in (Fig.5-3).

*Any hob hood should be installed in accordance with the

hood manufacturer’s instructions.

Surfaces of furniture and walls at the sides and rear of the hob

should be heat, splash and steam resistant. Certain types of

vinyl or laminate kitchen furniture are particularly prone to

heat damage and discolouration.

We cannot accept responsibility for damage caused by

normal use of the hob to any material that de-laminates

or discolours at temperatures less than 65°C above room

temperature.

For safety reasons curtains must not be tted immediately

behind the hotplate.

Conversion to LP

If the appliance is to be converted to LP gas do the

conversion at this point. See the conversion section of these

instructions.

ArtNo.316-0011 60cm hob clearances Gas

150mm

min

150mm

min

650mm min

600mm min

55mm min

21mm

min

Fig.5-1

Fig.5-2

Fig.5-3

ArtNo.316-0016 RGG60 cutout dims

510

620

560

480

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Rangemaster RGG60 Guide de l'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Rangemaster RGG60